Forster Full Length Bench Rest die set, 6.8 Remnigton SPC (004622) - in very nice shape. Got out of the 6.8 a while back and don't need these anymore. Forster dies are not cheap, but a better off-the-shelf die set just ain't out there. These run well over $100 new if and when you can find them in stock.

$85 $70 shipped

Payment by check, money order, or Zelle is fine, but absolutely NO paypal.

bump for a little attention

Does the bullet seater also crimp? I ask as a "bump" for your thread, and also if someone is looking at these that is pertinent information. I only have 6.8's in AR platforms and I must crimp all of my loads to prevent bullet movement in the case for those rounds in the magazine.

No, these dies will not crimp.

I never found crimping necessary at all, and I would suggest that if your bullets are getting set back during recoil or chambering (but especially in the magazine under the recoil of a 6.8!!), then your expander ball is too large.

I have never had set-back happen, but I have just always crimped as a course of safety... Imagine being out in the middle of a field 2 miles from your truck at 2AM hunting hogs, 3 hours away from home, and realizing your ammo is no good.... hence why I always put a slight crimp-nothing major-on all of my 6.8 rounds. Maybe it's not necessary, but I'd sure hate to find out the hard way.

Another bump... Hopefully someone will snatch these up soon...

Up for another look.

Offers welcome.