So my Form 1 just got approved and it took less than 30 days! I was pretty stoked to say the least - still waiting on my Suppressor though. That should come in around March next year.
Anyway, I will be getting my lower engraved tonight at Ident, but I am wondering who or if there is a gunsmith that I could take to swap out my barrels. Noveske 16" swapped to a Noveske 10.2". Additionally, I am dropping an SLR Rifle works 9" Solo Hand rail to replace the 11" Noveske NSR Rail.
I am out in Rockwall and normally either do stuff myself or if I think I am going to jack up my stuff I take it to Ammo Depot out in Caddo Mills. Every time I have called there, I cannot get through.
Any thoughts or suggestions?

Cheer,
TX Grubby

If you have a bench vise, then I'd suggest you just buy the AR15 clamshell vice block (about $30) so you can do the barrel swap yourself. It's pretty simple if you have the equipment.

Just buy the stuff. That way you've got it for the next one. It's really easy.

It's too easy , do it yourself

Yeah I agree a barrel swap on a AR is a cakewalk buy the stuff and do it yourself, you will be glad you did.

She is all done! 10.2" Noveske 300BLK - Now the wait for the can to get out of jail..



The original 16" Noveske 300BLK barrel is shown above with the 11" NSR Rail. Below is what she looks like now. Can't wait to go shooting!

TX Grubby