So basically this weekend I got tired of cleaning up sawdust. So it's time to make a disposal system. Unfortunately the day I was going to build it (labor day) I spent throwing up every 15 minutes from food poisoning. Yesterday wasn't much better.

But tonight I gutted it out and got some work done. I built a double cyclone system to pick up all debry. I need a larger shop vac but this actually works very well.

Will post more pics with progress. Still need to add valves for when I am using what saw and so on

I have one of these. http://www.amazon.com/Woodstock-W2049-2-...+dust+collector

And another one of these. http://www.amazon.com/Oneida-Molded-Dust...+dust+collector

The Oneida works great, I don't care for the height that it sits, but I prefer how it works over the top one.

That's a cool idea. Why ridged PVC vs lg rubber hose?

Yea DC that Oneida is nice. Eventually I wanna completely redo the shop with new saws, equipment, insulate the shop, etc. and will buy a commercial unit.

Saw this DIY online, and it actually works very well so far. But will have to install valves so that the suction is only directed towards one saw at a time.

SW, I really dont know, didnt even think about it.

Pretty cool East.

Pretty Sharp Amigo my Pops did one out of the same concept and used dryer vent flexible hose

Not bad for somebody that chews their fingernails.

I dont chew my damn fingernails

Made some progress tonight

Built a valve system to make sure whatever saw I'm using gets 100% vac attention.









This setup actually gets the router fence and underneath.



Trial run. I routed this piece of MDF down 1" on each side and didn't have any residue on the floor

The black hose is removable

That'll work right there, East!

Is my ex over there? I see her ride propped up on the lawn mower.
You are going to need bigger buckets

I also had that problem when I had a big shop, not it takes a long time to fill a 5 gallon bucket.

Awesome work East

Interesting

Finally got all vacuum system done and redid a radial arm table in the mean time



Before



After

That will work! Looks good

Nice East. 2 shop vac teed together for main line will certainly pull even more dust. Come out to FloMo and pick mine up!

There shall be no saw dust

Had to change it up under the table saw a bit











Now this actually works very well, finally

Some redneck engineering at it's finest.

Nice work amigo.

That is awesome. You took it to a whole new level!

The most I've ever done, is to drill a hole through the discharge on my radial arm saw, so I could pin the shop vac hose to it. I trimmed out quite a few houses that way, without too much to clean up.