|
|
dgilbert
THF Trophy Hunter
Reged: 09/04/04
Posts: 5694
Loc: Weatherford, Tx.
|
Re: Carpet tacks not working!
07/19/08 01:00 PM
|
|
|
OK, I will try to draw a picture here.
Take 4" PVC cut it so it will be about 6" from the bottom of the feeder leg and about 1' or 1'1/2 from bottom of feeder barrel.
Take feed leg off and slide leg through PVC.
Take a small piece of chain(that little size stuff) about a 1' long.
Screw or bolt chain to the top edge of the PVC and then screw the other end of the chain on the top of the feeder leg or the bottom of the feeder barrel.
Your PVC can not be touching the ground, it has to be loose so it can spin(PVC) in either direction.
Put a large varmit cage around your spinner will also help, between the both, tis should take care your problem.
I hope this helps, if you make it tough on them getting anything to eat, they will move on.
--------------------
|
|
3 registered and 6 anonymous users are browsing this forum.
Moderator: Big_Orn, HWY_MAN, HighTechRedneck, BuckMaster, JohnWester, dgilbert, Guy, gr_elliott, jeh7mmmag, TreeBass, Team Hillbilly
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Thread views: 500
|
|
|
|
|
|
Powered by UBB.threads™ 6.5.5
©2007 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide.
|
Previous
Index
Next
Flat
Edit
Reply
Quote
