|
|
Sharc
Light Foot
Reged: 03/19/07
Posts: 32
|
|
I am thinking about building a 4 x 6 hunting blind and was just curious how you guys handle the seam on the 6' wide side. I am interested in knowing the best way to do this.
|
Roger
Woodsman
Reged: 12/13/05
Posts: 162
Loc: McKinney
|
|
Ever seen board and batten siding. That's how I do mine. But em up and use a batten to cover the seam and caulk. I just have the 2 foot section offset. Doesn't bother me, But if you are picky I guess you can center it but it is a waste to me. Deer don't care about symetry.
|
Sharc
Light Foot
Reged: 03/19/07
Posts: 32
|
|
Thx,...I can figure that out !
|
TXBowhunter1
THF Trophy Hunter
Reged: 02/03/06
Posts: 6395
Loc: Carrollton,TX
|
|
put a 2x4 down the seam on the inside....also make that 2x4 one end of you window. 
--------------------
  
|
GreenAggie
Outdoorsman
Reged: 11/14/07
Posts: 97
|
|
I would run the plywood sideways. This way the seam is horizontal and you can use the metal edging that goes behind the top sheet and over the bottom sheet to keep water out.
|
|
2 registered and 3 anonymous users are browsing this forum.
Moderator: Big_Orn, HWY_MAN, HighTechRedneck, BuckMaster, JohnWester, dgilbert, Guy, gr_elliott, jeh7mmmag, TreeBass, Team Hillbilly
Print Topic
|
Forum Permissions
You cannot start new topics
You cannot reply to topics
HTML is disabled
UBBCode is enabled
|
Rating:
Topic views: 401
|
|
|
|
|
|
Powered by UBB.threads™ 6.5.5
©2007 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide.
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
