Posted By: dcrancher
Bull elk tearing up a feeder - 11/10/14 12:09 PM
Not news to anyone that raises elk...
We changed every other feeder to a welded 2"x4" panel but didn't make time for this one because the varmint cage was new last season.
Posted By: Elkhunter49
Re: Bull elk tearing up a feeder - 11/10/14 12:28 PM
They are hard on the equipment without a doubt! Maybe it's time for a 180 grain attitude adjustment.
Posted By: Circle NA Ranch
Re: Bull elk tearing up a feeder - 11/10/14 12:34 PM
Elk hunter 49.... That cracked me up!! I agree with Chief Joe... Nice elk!!
Posted By: mulie_mike
Re: Bull elk tearing up a feeder - 11/10/14 06:11 PM
He definitely tore it up, nice looking bull
I had the same problem. Now I run 11 feeders and no problems in 2 years. It will cost you $25 or less. Take a cattle panel and hold it across two legs of your feeder just under the barrel. Then use bolt cutters to cut panel to match the shape of your feeder legs. Cut your panel long on both ends so you can use big pliers to bend the panel around the legs. I also put wire on to double secure it to the legs because I was really tired of fixing the feeder. Repeat all of this around all the legs. I also left the varmint cage on for the coons. You will have to cut a square out of the panel to open the varmint cage and access timer. It took about 45 minutes but it has lasted 2 years. Before, I was repairing 2 feedersa week. Send me a text request for a photo and I will send it.254-625-2227... while I figured out how to out smart the elk, I can't figure out how to post a picture here.
Posted By: dcrancher
Re: Bull elk tearing up a feeder - 11/14/14 12:31 PM
Thanks for the info Double K; the picture below was my answer for both the elk and the raccoons bending the cheap cages available commercially; also using eliminator spin plates for the coons. That is 2"x4" horse panel fully welded to the bottom of the barrel with a hinged door on the front. So far so good but if the elk get past my fix I may be hitting you up for some pictures!
DC rancher, I believe that is going to work. It's the same principle as what I have done except I went around the legs of the feeder. Varmint cages are just too flemsey. Good Luck.
Posted By: HuntKill
Re: Bull elk tearing up a feeder - 11/26/14 04:05 PM
Just standing there for the camera...proud of his work...lol
Very nice elk
Not news to anyone that raises elk...
We changed every other feeder to a welded 2"x4" panel but didn't make time for this one because the varmint cage was new last season.
Not news to anyone that raises elk...
We changed every other feeder to a welded 2"x4" panel but didn't make time for this one because the varmint cage was new last season.
Posted By: michael89
Re: Bull elk tearing up a feeder - 11/26/14 07:13 PM
hello....I'm Michael and I a user new... I write from italy and I' m hunting enthusiast ....
Posted By: Elkhunter49
Re: Bull elk tearing up a feeder - 11/26/14 07:57 PM
hello....I'm Michael and I a user new... I write from italy and I' m hunting enthusiast ....
Hello Michael, welcom to Texas Hunting Forum. Baker
Posted By: Shadeabby
Re: Bull elk tearing up a feeder - 11/27/14 01:04 AM
Be happy to solve that problem by removing him all togther for you