needing barrel threaded

who is best bet

Where are you located?? $150 usually done in a couple days. Junction TX

This is who is always talked about on here.

https://class3machining.com/#services

I've heard there's someone in the Plano/Wylie area that is considered A#1 for this in the entire country, but you can't drop off...still have to ship it. I don't recall the guys name or company name, but maybe someone here will remember....

Class 3 machining named above your post. He's in Rowlett.

class 3 machining is GTG

[quote=https://class3machining.com/#services[/quote]

^^^This^^^ Morgan has done several for me with 100% satisfaction.

Jon Trammel

Morgan at class3!

Depends on where you're located. I've used Grumpy's Guns in Arlington & Mitchell's Gunworks in Breckenridge. Both do good work. Grumpys is closer to me so I have used him on the last few. Last one was a hunting rifle he had to build a lip for since the barrel profile was too thin. Did a great job.

Where are you located? That would help.

Jon Trammel Breckenridge , Tx 254-559-3455

appreciate the replies

Morgan it is