Hello all, this is my first post so please bear with me.

I have approx 90lbs of 9mm brass and about 50lbs of 223. All the brass still have the primers and the brass has not been put through a tumbler to clean it.

I'm in the San Antonio area and from what I've seen online 2.50 per lb is the going rate, plus shipping.

So there is no confusion (I hate confusion) I'm using the following standards for cases per pound
9mm: 120 cases per pound (easy math)
223: 75 cases per pound (easy math)

I am not set up to take credit. If you're in the San Antonio area I can meet you half way and you'll save the shipping (which is what I'd rather do to keep your costs down). If it needs to be shipped, I'll try and find the lowest ground and let you know the cost prior to closing the deal.

Again, this is my first attempt at this and this offer will expire on 24 November at noon (CST).

Thanks

What are the brand of brass are they all the same or missmatched. are they mil surplus... Are they all once fired, good contiditon or are they all dented up?

matt

All brass, fired once, I ran two ranges (one a month ago and one this past weekend). 9mm CCI (Lawman) and Federal (American Eagle i think) mix and the 223 is Federal.

Non - mil surplus but there may be a couple of mil surplus rounds (less than 1%) that were picked up but by far was single fired commercial ammo.

Most brass is non dented, picked up at the end of each day of shooting. Can't say that there are not a few dented ones but the majority are in good condition.

As You can see I am in the Cibolo are, where are you located at in san antonio.

I am interested in some of the 223 brass. Would meeting this weekend sometime work? Let me know here or in a PM I dont care.

matt

Matt, I'm in converse so we could meet at the Forum. I'm busy Sat morning / early afternoon (shooting). How many pounds of 223 brass so I sort and bag it?

For anyone else... have lots of 9mm brass!!!!!